A private operating layer for AeroLux experiments, live sensor evidence and AI-assisted learning.
Sign in with your Klopt Portal account.
KLOPT PORTAL / HOME
Your account is authenticated, but it is not yet assigned to the AeroLux workspace. Ask the Klopt administrator to activate access.
Run tests and review sensor data.
Start a test first. After that, incoming ESP32 data will be linked to that test.
Each test keeps its mixture, timing and sensor data together.
These are the sensors/channels the system can save when ESP32 sends data.
Telemetry controls only what is sent to the portal; they do not remove power from a sensor. All channels return ON after an ESP32 reboot.
GPIO6 enable path. Speed remains manual through the planned potentiometer.
DRV8833 direction demo on GPIO8 / GPIO9. First jog disables ENS160/TVOC until reboot because those pins are currently shared.
The fan model and driver are not documented yet, so portal control is intentionally unavailable.
Build, verify and deploy ESP32 firmware without Arduino IDE once OTA bootstrap is installed.
The ESP32 is online, but its currently installed firmware cannot update itself yet. Build the OTA bootstrap release below, then open this portal in Chrome/Edge on the computer physically connected to the ESP32 and use USB Bootstrap. Arduino IDE is not required.
No diagnostic capture yet.
Waiting…
Use this only for the first OTA bootstrap or recovery. It flashes the latest compiled factory image directly over USB from Chrome/Edge. Arduino IDE is not required.
Select an AeroLux .ino source file. The server compiles it against the same ESP32 core and board definition used on the laptop, then calculates a SHA-256 hash and stores the release.
Choose a recorded test to review its results and plan the next test.
Use New test to record an experiment. Sensor diagnostics are for wiring checks.
Choose a test and select Do AI Analysis for key findings and a suggested next test.
| Channel | First → latest | Samples |
|---|
Water Level and BMP180 OUT are excluded. MQ-7 and turbidity values are raw signals; calibration is needed to assess treatment performance.
Enter the mixture first. Incoming sensor data will be linked to this test.
Loading…
Use at least 8 characters.